Dispensing tips for special sprinklers

Transmission gear is divided into low speed, medium speed, high speed and reverse gear, Dongfeng EQ1061 \ EQ1092 \ EQ1108 \ EQ1141 series of five-speed gearbox are in the first and second gear for the low gear, three gear for the speed gear, four, five gear High speed gear. The lower the gear, the greater the speed ratio, the lower the speed of the drive shaft of the vehicle and the greater the drive torque on the wheel, the greater the traction of the vehicle; conversely, the smaller the driving force of the vehicle. For this reason, when the car needs a large traction (such as starting, uphill, bad road, etc.), should choose a block or a second block, when you want to shift from low to high or high to low, or in the turn, When the car and the ramp are traveling, the third gear is selected. When the road conditions are good, the four or five gears should be used.

Inadequately added upshifts and late downshifts are too late to cause the driveline to flutter due to lack of power, and to accelerate the operation of certain components to accelerate the damage of some components; on the contrary, if the upshift is too late and the downshift is too early, it will make The engine accelerates wear and consumes unnecessary fuel. Therefore, during driving, the gear must be changed according to the vehicle load, road conditions, and driving requirements.

Low-speed gear change high-speed gear: increase the throttle before the upshift to increase the speed of the vehicle. When reaching the speed suitable for a high-level gear change, immediately release the throttle, quickly depress the clutch pedal and push the gear lever to the neutral gear. Then lift up the clutch pedal, stop and then step on, and then shift the gear accurately by the neutral gear to shift a higher gear, and then gently lift the clutch pedal, gradually increase the throttle, so that the car continues to drive.

High-speed gear change low gear: When lowering the gear, press the clutch pedal while releasing the throttle, move the shift lever to neutral, then lift the clutch and immediately apply the throttle (add empty oil), and then quickly depress the clutch pedal. Change the gear lever to a lower gear, then slowly lift the clutch pedal and increase the throttle at the same time to make the car continue to drive. Dongfeng EQ1118G and EQ1141G series vehicles are equipped with supercharged engines. Because supercharged engines have the characteristics of low low-speed torque and high mid- and high-speed torque, they should be reduced in advance when climbing uphill, without delay.