The minimum turning diameter of the car

The minimum turning diameter is actually a non-standard term that indicates the performance of the car. The turning diameter is the normative expression, which is a parameter that indicates whether the vehicle's cornering performance is flexible or not. In general, the turning diameter given in the vehicle specification refers to the diameter of the orbital circle of the outer steered wheel. It refers to the trajectory circle diameter of the center plane of the outer steering wheel of the vehicle on the vehicle support plane (generally the ground). When the front wheel of the vehicle is traveling at the maximum corner, the front axle of the car is farthest from the center of the tire tread of the steering center. The diameter of the trajectory circle formed on the ground. That is, the diameter of d1 in the figure.

Since the left and right extreme corners of the steering wheel are generally different, there are left and right turning diameters.

Turning diameter directly affects the mobility of the car. The smaller the turning diameter, the greater the ability of the car to pass through a narrow curved zone or to bypass unobstructed obstacles, the more flexible it is. The turning diameter is directly related to the wheelbase of the car, the wheelbase and the limit rotation angle of the steering wheel. The greater the wheelbase and wheelbase, the larger the turning diameter. The larger the limit turning angle of the steering wheel, the smaller the turning diameter.

The turning diameter is directly related to the wheelbase of the car, the wheelbase and the limit rotation angle of the steering wheel. The greater the wheelbase and wheelbase, the larger the turning diameter. The larger the limit turning angle of the steering wheel, the smaller the turning diameter. The minimum turning diameter is one of the performance indicators that a small car can raise in the face of a large luxury car.

Silicone Rubber Mould

Silicone mould is a special mold for making crafts. According to performance, the raw materials of glue can be divided into ordinary silicone and weather silicone. The characteristics of silicone are high temperature resistance, corrosion resistance, strong tear resistance, high simulation precision, and it is used to make various handicrafts mold.

Mold should be made in time after the silicone is matched. Pour the glue on the highest part of the mold in a trickle, let it flow naturally, brush it in place with an oil paintbrush where the flow is not in place, if it is a piece of silicone, not only fill the entire product, but also brush the glue evenly. Each product should be brushed with at least three layers of silicone. The thickness of each layer of silicone is 1mm. In the process of brushing the silicone, each layer is required to be cured before the other layer can be brushed. When brushing the third layer, add one layer on top of the second layer. The thickness of the silica gel part of the whole mold is controlled in 3-4mm according to the different requirements of the size of the product, and the width is not greater than 60 mm of the product width. The time for the silicone to set is 20 minutes.

Silicone Injection Molding, Moulding Silicone, Rubber Molds, Rubber Mold Making

Sung Precision Mould & Plastic Co., Ltd. , https://www.gdinjectionmolding.com