How to avoid internal water in the wet magnetic separator

As we all know, the wet magnetic separator is an important equipment in the beneficiation equipment, and there are many places where it is used. It is inevitable that such or such small faults will occur. If the equipment enters water, it will affect its service life and The effect of the use of magnets, then how do we not let the wet magnetic separator into the water? First of all, we must ensure the daily maintenance of the wet magnetic separator, so as to ensure that it is not easy to enter the water, here are a few to pay attention to: First, the slurry should be passed through a layer of sieve before feeding the wet magnetic separator. To remove debris; Second, diligently check the belt clip, found that it will be bad, pre-maintenance work to reduce the number of belts; Third, to prevent the wet magnetic separator operating under overload conditions, to avoid excessive processing capacity Causes the belt to fall off and blockage; Fourth, in the production must listen to the sound inside the cylinder frequently, especially after starting to examine carefully once, if finds the different sound, must carry on the inspection by the single parking place, removes the obstacle. Secondly, to prevent the important conditions of water intake, we have also put together a few: First, improve the quality of maintenance, so that the end cap does not penetrate clean water; Second, the wet magnetic separator drive belt off the first to stop the chromium ore and close the water gate Further processing, this can avoid the rise of the water level in the box, resulting in the phenomenon of water inflow; Third, establish a strict shift system. Afterwards, in the ordinary course of use, we must strictly follow their instructions for use. Only in this way can we achieve safe production.