1, first check the suction pipe does not allow the existence of air leakage phenomenon, otherwise the suction truck will not work.
2. When the suction truck is used in the new pump, it should directly add 1-2 liters of No.32 mechanical oil to the pump. Our new car is delivered with a Manual of Manuals. Please refer to the instructions in the book for adding. For the same type of oil, a moisture separator should be installed at the suction port of the pump.
3. The oil return port of the primary oil and gas separator of the suction truck must be connected to the oil return port of the secondary oil and gas separator and the suction pipe must be made of a rigid pipe or hard oil resistant rubber hose (steel wire braided hose). Thermally deformed plastic tubes are not allowed.
4. Suction truck body is installed with spill-prevention device, otherwise it will be easy to suck waste water into the vacuum pump when using suction truck to damage the whole system.
5, the amount of oil adjusted back to the oil storage tank should not be too much, to the lower surface of the oil level tube is appropriate, storage oil supply is too easy to affect the effect of oil and gas separation, so that increased fuel consumption, and vice versa Affect the cooling, make the vacuum pump temperature rise too quickly.
Suction truck manufacturer's staff reminds you that the owner of the suction truck: It is very important that the suction truck is used for the first time. If the commissioning is not in place, it will cause unnecessary losses in the subsequent suction truck work!
Splash Series,Splash Toys,Inflatable Splash Pad,Splash Mat
P&D Plastic Manufacture Co., Ltd , https://www.leadingproduction.com